Digi Connect EZ Mini User Manual page 72

Interfaces
n
11. (Optional) Click to expand MAC address blacklist.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address blacklist.
a. Click to expand MAC address blacklist.
b. For Add MAC address, click .
c. Type the MAC address.
12. (Optional) Click to expand MAC address whitelist.
If there whitelist entries are specified, incoming packets will only be accepted from the listed
MAC addresses.
a. Click to expand MAC address whitelist.
b. For Add MAC address, click .
c. Type the MAC address.
13. Click Apply to save the configuration and apply the change.

Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or edit an existing one:
To create a new WAN named my_wan:
n
(config)> add network interface my_wan
(config network interface my_wan)>
To edit an existing WAN named my_wan, change to the my_wan node in the
n
configuration schema:
(config)> network interface my_wan
(config network interface my_wan)>
4. Set the appropriate firewall zone:
(config network interface my_wan)> zone zone
(config network interface my_wan)>
See Firewall configuration
Digi Connect EZ Mini User Guide
See Configure system information
device's system name.
for further information.
Wide Area Networks (WANs)
for information about setting the Connect EZ
72