Table of Contents
Advertisement
Serial port
For rts_post_delay, enter the amount of time RTS is deasserted before completing
l
data transmission. The time is measured in milliseconds. The default is 0ms:
rs-422
n
Enable Termination if you want to enable electrical termination on this serial port.
l
rs-485
n
Enable termination if you want to enable electrical termination on this serial port:
l
Enable full_duplex if you want to enable full duplex communication on this serial
l
port:
The default is rs-232.
7. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel label
(config)>
8. Expand Serial Settings.
The entries in the following fields must match the information for the power controller. Refer
to your power controller manual for the correct entries.
a. Baud rate: For Baud rate, select the baud rate used by the device to which you want to
connect. The default is 9600.
b. Data bits: For Data bits, select the number of data bits used by the device to which you
want to connect. The default is 8.
c. Parity: For Parity, select the type of parity used by the device to which you want to
connect. The default is None.
d. Stop bits: For Stop bits, select the number of stop bits used by the device to which you
want to connect. The default is 1.
e. Flow control: For Flow control, select the type of flow control used by the device to
which you want to connect. The default is None.
1. Set the baud rate used by the device to which you want to connect:
(config)>path-parambaudrate rate
(config)>
Digi Connect EZ Mini User Guide
(config)> serial port1 "rts_pre_delay value
(config)>
(config)> serial port1 rts_post_delay value
(config)>
(config)> serial port1 termination true
(config)>
(config)> serial port1 full_duplex true
(config)>
Configure Modbus mode
111
Advertisement
Table of Contents
