Dual Boot Behavior - Digi Connect EZ Mini User Manual

Firmware version 22.2

Hide thumbs Also See for Connect EZ Mini:

Table of Contents

System administration

> scp host 192.168.4.1 user admin remote /home/admin/bin/Connect EZ-

22.2.9.85.bin local /etc/config/ to local

admin@192.168.4.1's password: adminpwd

Connect EZ-22.2.9.85.bin

4. Verify that the firmware file has been successfully uploaded to the device:

> ls /etc/config/scripts

22.2.9.85.bin

5. Update the firmware by entering the

firmware file name:

> system firmware update file Connect EZ-22.2.9.85.bin

netflash: got "/etc/config/Connect EZ-22.2.9.85.bin", length=37511229

netflash: authentication successful

netflash: programming FLASH device /dev/flash/image

Firmware update completed, reboot device

6. Reboot the device to run the new firmware image using the

Rebooting system

7. Once the device has rebooted, log into the Connect EZ's command line as a user with Admin

access and verify the running firmware version by entering the

> show system

Current Time

Dual boot behavior

By default, the Connect EZ device stores two copies of firmware in two flash memory banks:

The current firmware version that is used to boot the device.

A copy of the firmware that was in use prior to your most recent firmware update.

Digi Connect EZ Mini User Guide

system firmware update

: Connect EZ

: 0040FF800120

: Digi Connect EZ

: Thurs, 03 March 2022 10:16:23 +0000

: 42 seconds (42s)

Update system firmware

37511229 May 16 20:10 Connect EZ-

2580 May 16 16:44 accns.json

command, specifying the