Table of Contents
Advertisement
Interfaces
(config network interface my_wan ipv4 surelink)> timeout value
(config network interface my_wan ipv4 surelink>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set timeout to ten minutes, enter either 10m or 600s:
(config network interface my_wan ipv4 surelink)> timeout 600s
(config network interface my_wan ipv4 surelink)>
The default is 15 seconds.
8. (Optional) Repeat this procedure for IPv6.
9. Save the configuration and apply the change:
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the device to reboot when a failure is detected
Using SureLink, you can configure the Connect EZ device to reboot when it has determined that an
interface has failed.
Required configuration items
Enable SureLink.SureLink can be enabled for both IPv4 and IPv6 configurations. By default,
n
SureLink is enabled for IPv4 for the preconfigured WAN. It is disabled for IPv6.
Enable device reboot upon interface failure.
n
The type of probe test to be performed, either:
n
Ping: Requires the hostname or IP address of the host to be pinged.
l
DNS query: You can perform a DNS query to a named DNS server, or to the DNS servers
l
configured for the WAN.
HTTP or HTTPS test: Requires the URL of the host to be tested.
l
Interface status: Determines if the interface has an IP address assigned to it, that the
l
physical link is up, and that a route is present to send traffic out of the network interface.
Additional configuration items
See for
Configure SureLink active recovery to detect WAN failures
n
configuration parameters.
Digi Connect EZ Mini User Guide
Wide Area Networks (WANs)
optional SureLink
59
Advertisement
Table of Contents
