Table of Contents
Advertisement
Interfaces
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.
See
Configure WAN priority and default route metrics
metrics.
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show WAN status and statistics
WebUI
1. Log into the Connect EZ WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the
show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
loopback
>
Digi Connect EZ Mini User Guide
command at the Admin CLI prompt:
Proto
Status
Address
-----
-------
-------------------------------
IPv4
up
192.168.210.1/24
IPv4
up
169.254.100.100/16
IPv4
up
10.10.10.10/24
IPv6
up
fe00:2404::240:f4ff:fe80:120/64
IPv4
up
127.0.0.1/8
Wide Area Networks (WANs)
for further information about
75
Advertisement
Table of Contents
