Digi Connect EZ Mini User Manual page 227

Virtual Private Networks (VPN)
3. (Optional) Set the UDP listening port that L2TP servers will listen on:
(config)> vpn l2tp port value
(config)>
where value is an integer between 1 and 65535. The default is 1701.
4. Set the access control for L2TP tunnels:
To limit access to specified IPv4 addresses and networks:
n
(config)> add vpn l2tp acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add vpn l2tp acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the Connect EZ
n
device:
(config)> add vpn l2tp acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add vpn l2tp acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Digi Connect EZ Mini User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Display a list of available firewall zones:
L2TP
227