Table of Contents
Advertisement
Services
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click again to allow access through additional firewall zones.
9. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a location source:
(config)> add service location source end
(config service location source 0)>
4. (Optional) Set a label for this location source:
(config service location source 0)> label "label"
(config service location source 0)>
5. Set the type of location source to server:
(config service location source 0)> type server
(config service location source 0)>
6. Set the UDP port that will receive incoming location messages.
(config service location source 0)> server port port
(config service location source 0)>
7. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service location source 1 acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the location server UDP port.
l
Repeat this step to list additional IP addresses or networks.
Digi Connect EZ Mini User Guide
See
Firewall configuration
for information about firewall zones.
Location information
292
Advertisement
Table of Contents
