Table of Contents
Advertisement
Get started with Connect EZ
Step 5: Configure RealPort from the Digi Navigator
You can configure the Connect EZ to communicate with your computer using RealPort from the
Navigator. You must enable RealPort on the device and then configure your computer for RealPort.
In this step, all serial ports on the device are set to RealPort mode and the RealPort service is enabled.
The COM ports on your laptop are also configured.
Note
You can also configure the device to accept a Realport connection from the web UI on the
device. See
Configure RealPort
1. Make sure theConnect EZ is
2.
Download and install
3. Launch the Digi Navigator.
4. Select the device you want to configure using one of the following methods:
Specify a device: Expand the Specify a device section and enter the IP address or host
n
name for the device.
Select a device: From the list of devices shown in the Digi Navigator, expand the
n
device that you want to configure.
5. Configure RealPort on the device.
a. Click the Configure device for RealPort button. A login screen displays.
b. Enter the device's default user name and password in the appropriate fields. The default
user name is admin and the default password is the unique password printed on the label
packaged with your device.
c. Click Submit. A progress message displays.
d. When RealPort configuration is complete, the Success message displays.
e. Click Close to close the message.
6. Configure RealPort on your computer.
Digi Connect EZ Mini User Guide
Step 5: Configure RealPort from the Digi Navigator
mode.
powered on and connected to your network or
the Digi Navigator.
Digi
computer.
19
Advertisement
Table of Contents
