Table of Contents
Advertisement
Services
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the External zone to the SSH service:
(config)> add service ssh acl zone end external
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the web administration service
The web administration service allows you to monitor and configure the Connect EZ device by using
the WebUI, a browser-based interface.
By default, the web administration service is enabled and uses the standard HTTPS port, 443. The
default access control for the service uses the Internal firewall zone, which means that only devices
connected to the Connect EZ's LAN can access the WebUI. If this configuration is sufficient for your
needs, no further configuration is required. See
for information about configuring the web administration service to allow access from remote
devices.
Required configuration items
The web administration service is enabled by default.
n
Configure access control for the service.
n
Additional configuration items
Port to use for web administration service communication.
n
Multicast DNS (mDNS) support.
n
An SSL certificate to use for communications with the service.
n
Support for legacy encryption protocols.
n
See
Set the idle timeout for Connect EZ users
the web administration services.
Digi Connect EZ Mini User Guide
Configure the web administration service
Allow remote access for web administration and SSH
for information about setting the inactivity timeout for
251
Advertisement
Table of Contents
