Port Configuration; Cli Configuration - Tripp Lite NGI-M08POE8-L2 Owner's Manual

6.12.2 Port Configuration

6.12.2.1 CLI Configuration

Node Command
enable show pppoe intermediate-agent
configuration
enable configure terminal
configure interface IFNAME
interface pppoe intermediate-agent
<enable|disable>
interface pppoe intermediate-agent trust
interface pppoe intermediate-agent
format-type <circuit-id|remote-
id><id-string>
interface pppoe intermediate-agent
vendor-tag <keep|replace|strip>
interface pppoe intermediate-agent vlan
VLANLISTS
interface no pppoe intermediate-agent
trust
interface no pppoe intermediate-agent
format-type <circuit-id|remote-
id>
interface no pppoe intermediate-agent
vendor-tag
interface no pppoe intermediate-agent
vlan
interface no pppoe intermediate-agent
vlan VLANLISTS
if-pppoe-vlan pppoe intermediate-agent
format-type <circuit-id|remote-
id><id-string>
if-pppoe-vlan no pppoe intermediate-agent
format-type <circuit-id|remote-
id>
Example:
L2SWITCH(config)#pppoe intermediate-agent enable
L2SWITCH(config)#pppoe intermediate-agent vlan 1-100,200,300
L2SWITCH(config)#pppoe intermediate-agent circuit-id-vlan 1-100,200,300
L2SWITCH(config)#pppoe intermediate-agent remote-id-vlan 1-100,200,300
L2SWITCH(config)#pppoe intermediate-agent format-type user-defined
%HOSTNAME+%SPACE+atm+%SPACE+/0/0/+%PORT+:+%CVLAN
Description
This command displays the current
configurations for the PPPoE IA.
This command changes the node to
configure node.
This command enters the interface
configure node.
This command disables / enables the PPPoE
IA on specific interface for the PPPoE IA.
This command setsaphysical
interfaceastrusted port.
This command sets circuit ID or remote ID
string on specific interface for the PPPoE
IA.
This command is used to set the
retransmitting policy of the specific
interface for the PADO/PADS packet.
Default:Keep
This command enables thePPPoE IA on
specific VLANs of interface.
This command setsaphysical interfaceas
untrusted port.
This command removes circuit ID or remote
ID string on specific interface for the PPPoE
IA
The command sets the retransmitting policy
of the specific interface as "keep".
This command disables thePPPoE IA on all
VLANs.
This command disables thePPPoE IA on
specific VLANs of interface.
This command sets circuit ID or remote ID
string on specific VLANs of interface for the
PPPoE IA.
This command removes circuit ID or remote
ID string on specific VLANs of interface for
the PPPoE IA.
204