Setup For The Whole System; Network Settings (Network Config Menu) - Sony DVS-9000 User Manual

Setup for the Whole System

Carry out operations relating to setup in the Engineering Setup menu.
To access the Engineering Setup menu, press the top menu selection button
[ENG SETUP].
For an overview of setup, see "Setup" in Chapter 1 (Volume 1).
Setting the unit ID
When there are two switchers and connected DME units on the same network,
it is necessary to set the unit ID on each device, as follows.
Switcher
1st switcher
2nd switcher
DME
DME1 for 1st switcher (channels 1 to 4)
DME2 for 1st switcher (channels 5 to 8)
DME1 for 2nd switcher (channels 1 to 4)
DME2 for 2nd switcher (channels 5 to 8)
For more details of how to make the unit ID settings, refer to the installation
manual for the particular device.

Network Settings (Network Config Menu)

To make the network settings, use System >Network Config menu.
To display the Network Config menu
In the Engineering Setup menu, select VF1 'System' and HF1 'Network
Config.'
The status area shows the device ID, and Control LAN and Data LAN IP
addresses for each device excluding the DCU.
Making the network settings
1
In the System >Network Config menu, press [Auto Config].
ID
1
2
ID
1
2
3
4

Setup for the Whole System

273