Safety Instructions; Microwave Radiations (Emf Norms) - Nokia 9500 MPR User Manual

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
1.3.5.2
Carefully observe the specific procedures for installation / turn-up and
commissioning / maintenance of equipment parts where heat-radiating mechanical
parts are present, described in the relevant installation / turn-up and commissioning
/ maintenance documents and the following general rule:
Personal injury can be caused by heat. Avoid touching powered terminals with any
exposed part of your body.

1.3.6 Microwave radiations (EMF norms)

Equipment emitting RF power (Reminder from site preparation procedure):
The site must be compliant with ICNIRP guidelines or local regulation if more
restrictive.
1.3.6.1
The following rules should be strictly applied by the customer:
Remind persons standing in front of the 9500 MPR antenna may cause traffic
shutdown.
Place the warning sticker, as shown in

Safety instructions:

Safety instructions:
• Non authorized persons should not enter the compliance boundaries, if any, for
the general public.
• Compliance RF boundaries, if any, related to Electro Magnetic Field exposure
must be marked.
• Workers should be allowed to switch-off the power if they have to operate inside
compliance boundaries.
• Assure good cable connection.
• Install the antenna as high as possible from floor or area with public access (if
possible the cylinder delimiting the compliance boundaries, if any, or the cylinder
corresponding to the transmission area directly in front of antenna with the same
diameter as the antenna, more than 2 meters high).
• Install the antenna as far as possible from other existing equipment emitting RF
power.
Figure 8, as follows:
Safety awareness
53