Left Hand Motion Control Installation; Right Hand Motion Control Removal - Toro GrandStand 74504TE Service Manual

Left Hand Motion Control
Installation
1. Install the grip on the left hand motion control
assembly.
2. Install the igus bearing onto end of the motion
control.
3. Lift left hand motion control assembly through the
tower and secure with bolt and nut in the front and
2 bolts on top of the tower. Ensure pivot tab is
installed (Figure 20). Torque to 75 +/- in. lbs.
Figure 20
4. Install bolt through the motion control assembly,
speed adjustment bracket, and upper control rod
end. Secure with nut. Torque to 36 +/- 4 ft. lbs.
5. Place bolt through the IHT control arm, and lower
end of control rod. Secure with nut. Torque to 36
+/- 4 ft. lbs.
NOTE: Forward position of slot for 10 mph, rear
position of slot for 8 mph.
NOTE: Ensure control rod does not rub on fuel
tank tube mount.
6. Once both sides are complete refer to section speed
settings, see "Speed Setting Procedure," page 6-2.
TORO®- Grandstand Service Instruction Manual

Right Hand Motion Control Removal

NOTE: IHT are shipped with the Internalized
Hydraulic Transmission. (show IHT arm on
drawing).
1. Lower the cushion.
2. Remove the fuel tank, see "Fuel Tank Removal,"
page 3-10.
3. Remove bolt and nut from slot on the right IHT arm.
4. Remove bolt and nut from the top of the control
holding pivot tab and right hand control assembly.
5. Remove control rod from the tower.
6. Unclip the right hand motion control switch.
7. Remove bolt and nut from the front of the tower.
8. Remove the 2 bolts and nuts securing the right hand
motion control to the tower.
9. Drop the right hand motion control through the
tower.
CONTROLS
4-3
4