Adjusting The Tracking; Checking The Tire Pressure - Toro Z Master Professional 6000 Series Operator's Manual

1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees
to change the roll bar
position.

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area and move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, loosen the
bolts and adjust the left stop plate rearward on
the left T-slot until the machine tracks straight
(Figure 65).
Figure 64
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-
EUTRAL LOCK
7. If the machine tracks to the left, loosen the bolts
and adjust the right stop plate rearward on the
right T-slot until the machine tracks straight
(Figure
8. Tighten the stop plate
g008943
1. Control lever
2. Bolt

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
Maintain the air pressure in the rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut.
Check the tires when they are cold to get the most
accurate pressure reading.
Note:
The front tires are semi-pneumatic tires and do
and
AST not require air pressure maintenance.
49
65).
(Figure
Figure 65
Left control lever shown
3. Stop plate
comes first)
65).
g027340