Checking The Wheel Lug Nuts; Adjusting The Tracking - Toro Titan MR4800 Operator's Manual

Checking the Wheel Lug Nuts

Check and torque the wheel lug nuts to 108 N∙m (80 ft-lb).

Adjusting the Tracking

When driving the machine forward full speed across a flat, level surface, if the machine pulls
to 1 side, adjust the tracking.
If the machine pulls to the left, adjust the right motion-control lever; if the machine pulls to
the right, adjust the left motion-control lever.
Note:
You can adjust the tracking only for driving forward.
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Locate the tracking-adjustment bolt near the motion-control lever on the particular side
that needs adjusting.
4. Rotate the bolt to decrease the speed for that particular wheel.
Note:
5. Start the machine and drive forward across a flat, level surface with the motion-control
levers fully forward to check if the machine tracks straight. Repeat the procedure as
needed.
3464-659A
Rotate the bolt a small amount to make minor adjustments.
position.
ARK
G453528
Page 5–20 Maintenance: Drive System Maintenance