Hour Meter - Toro ProLine H800 Service Manual

Hour Meter

Electrical System: Testing the Electrical Components
g213963
1. Fuel gauge
2. Engine-temperature gauge
3. Height-of-cut switch
The hour meter records and displays the accumulated hours of the engine
operation.
The service due indicator displays the number of hours until the next engine oil
and filter change.
Note: The indicator flashes automatically with "OIL CHANGE" when you need to
change the engine oil and filter.
The service due indicator also displays the number of hours until you need to
grease the machine.
Note: The indicator flashes automatically with "LUBE" when you need to
lubricate the machine.
Push the button ON the hour meter/service due indicator to select the function
on the screen.
During the first 50 hours while in the oil change mode, take care
to not inadvertently hold the button of the hour meter longer than
6-seconds. Holding the button longer than 6-seconds will set the oil
service interval from 50 hours to 250 hours.
After changing the engine oil and filter or lubricating the machine and mower
deck, perform the following:
1. Push the button until you reach the desired screen.
2. Push and hold the button for 6 seconds until the indicator stops flashing.
Note: You cannot reset the total working hours of the machine.
Figure 125
4. Hour meter/service due indicator
5. Throttle lever
IMPORTANT
Page 6–28 ProLine H800
19241SL Rev A