Toro ProLine H800 Service Manual page 291

Installing the PTO Driveshaft
ProLine H800
19241SL Rev A
If the driveshaft tube and shaft were separated, ensure that the slip
shaft yoke and slip tube yoke are aligned when the tube and shaft
are assembled. Misalignment of the yokes will result in shortened
driveshaft life and will cause unnecessary vibration when the cutting
deck is operated.
1. If removed, install the PTO driveshaft (16) into the polyethylene tube protector
(20) using the Figure 158
2. Position the PTO driveshaft to the machine.
Note: Ensure that the slip shaft yoke is toward the cutting deck gearbox shaft.
3. Align the splines of the PTO driveshaft end yoke onto the PTO shaft. Press
the spring loaded pin and slide the PTO driveshaft end yoke onto the PTO
shaft.
4. Release the spring loaded pin and check that the PTO driveshaft end yoke is
locked onto the PTO shaft.
5. Secure the polyethylene tube protector (20) with the bracket (28), bolt (29),
washers (13) and nuts (27) to the chassis.
6. Align the splines of the PTO driveshaft end yoke onto the cutting deck
gearbox shaft. Press the spring loaded pin and slide the PTO driveshaft end
yoke onto the cutting deck gearbox shaft.
7. Release the spring loaded pin and check that the PTO driveshaft end yoke is
locked onto the cutting deck gearbox shaft.
8. Close the universal joint cover (item 1 in
quarter turn fastener.
9. Lubricate the PTO driveshaft grease fittings; refer to Operator's Manual.
IMPORTANT
as a guide.
Figure
Page 8–19
159) and secure with the
Axle and PTO: Service and Repairs