Toro ProLine H800 Service Manual page 165

Removing the Rear Wheel Motor (continued)
ProLine H800
19241SL Rev A
6. Remove the rear wheel from the machine; refer to
(page 7–3).
7. Remove wheel hub from the rear wheel motor as follows:
Do not hit the wheel hub, wheel-hub puller, or wheel motor with a
hammer while removing or installing. Hammering can damage the
wheel motor.
A. Ensure that the locknut on the wheel motor shaft is loosened at least
2 turns.
B. Use a wheel hub puller (refer to
wheel hub from the wheel motor.
C. Remove the locknut and wheel hub from the motor shaft. Discard the
locknut.
D. Locate and retrieve the woodruff key (item 4 in
motor shaft.
IMPORTANT
Special Tools (page
Page 5–97
Removing the Wheels
2–15)) to loosen the
Figure 79) from the wheel
Hydraulic System: Service and Repairs