Auxiliary Control Valve - Toro ProLine H800 Service Manual

Auxiliary Control Valve

g293274
1. Knob
2. Nut
3. Spring
4. Puller knob
5. Spring
6. Auxiliary valve lever
7. Connector
Remove the Auxiliary Control Valve
Hydraulic System: Service and Repairs
8. Auxiliary valve lever
9. Bolt
10. Washer
11. Auxiliary valve lever
12. Auxiliary control valve
13. Auxiliary control valve support
14. Bolt
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Drain the hydraulic fluid from the tank into a suitable container; refer to
Operator's Manual.
3. Remove the right console to get access to auxiliary control valve; refer to
Disassembling the Body Assembly (page
4. Clean the hydraulic hose ends and fittings on the hydraulic tank to prevent
contaminants from entering into the hydraulic system.
5. For assembly purposes, label all the hydraulic hoses and fittings.
Figure 67
15.
16.
17.
18.
19.
7–6).
Page 5–78
Washer
Nut
Band clamp
Band clamp
Washer
ProLine H800
19241SL Rev A