Rear Wheel Motors
g293711
1.
Bolt
2.
Hydraulic motor
3.
Spindle
4.
Woodruff key
Removing the Rear Wheel Motor
Hydraulic System: Service and Repairs
5.
Washer
6.
Nut
7.
Flange
8.
Nut
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Block the front wheels with chocks to prevent the machine from moving.
3. Loosen, but do not remove the locknut (item 8 in
the wheel hub to the wheel motor.
4. Read the
General Precautions for Removing and Installing the Hydraulic
System Components (page
Before lifting the machine with a jack, review and follow
Instructions (page
1–7).
5. Lift the machine with a jack to remove the rear wheel, support the machine
with jack stands.
Figure 79
10.
11.
CAUTION
Releasing Pressure from the
5–5).
5–63).
IMPORTANT
Page 5–96
9.
Washer
Bolt
Spindle
Figure
79) that secures
Jacking
19241SL Rev A
ProLine H800