Toro ProLine H800 Service Manual page 57

Removing the Radiator (continued)
ProLine H800
19241SL Rev A
g289054
1. Oil cooler
2. Nut
3. Bolt
4. Washer
Before opening the hydraulic system, operate all hydraulic controls
to relieve system pressure and avoid injury from pressurized
hydraulic fluid.
7. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
8. Clean the hydraulic tube ends and oil cooler fittings to prevent hydraulic
contamination.
9. Disconnect the hydraulic hoses from the radiator. Position hoses away from
the radiator.
10. Cover or plug the hydraulic hoses to prevent contamination.
11. Disconnect the radiator hoses (upper and lower) from the radiator.
12. Loosen the hose clamp and remove overflow hose from the radiator fill
opening.
13. Remove coolant reservoir from bracket on the cable guard.
14. Disconnect the electrical power connector of the blower. Remove the 4 nuts
and 4 bolts that secures the blower to the radiator.
15. Remove the blower from the radiator.
16. Support the radiator assembly before loosening mounting fasteners.
17. Remove the 2 nuts and 2 bushings that secure the radiator to the radiator
support.
18. Carefully pull the radiator assembly from the machine. Plug the radiator and
hose opening to prevent contamination.
19. If necessary, disassemble the radiator
Figure 16
5. Bracket
6. Hydraulic hose
7. Hydraulic hose
CAUTION
5–63).
(Figure
Page 4–9
14).
Engine: Service and Repairs