Toro ProLine H800 Service Manual page 54

Removing the Exhaust System (continued)
Installing the Exhaust System
Engine: Service and Repairs
3. Allow engine and exhaust system to cool before doing any disassembly of
exhaust system components. Get the access to exhaust system components.
4. Raise and lock the hopper assembly; refer to Operator's Manual.
5. Remove the top engine cover and rear engine cover assemblies (refer to
Frame Assembly (page
6. Remove the exhaust pipe as shown in
Note: Ensure that all exhaust system flanges and sealing surfaces are free of
debris or damage that may prevent a tight seal.
1. Ensure to install new gaskets in place of all gaskets that were removed. Do
not use any type of gasket sealant on gasket or flange surfaces.
Finger tighten all fasteners before securing the muffler to the engine
so there is no preload on the exhaust system.
2. Assemble the exhaust pipe as shown in
3. After exhaust system components are properly installed, install and secure
the top engine cover and rear engine cover assemblies (refer to
Assembly (page 7–19)).
4. Unlock and lower the hopper assembly; refer to Operator's Manual.
7–19)) and get access to exhaust pipe.
Figure
IMPORTANT
Figure
Page 4–6
13.
13.
Frame
ProLine H800
19241SL Rev A