Toro ProLine H800 Service Manual page 265

Removing the Traction Pedal (continued)
Installing the Traction Pedal
ProLine H800
19241SL Rev A
4. Disassemble the traction pedal as needed using the
When removing the pin (21), make sure to support traction pedal pin (25) to
prevent damage.
1. Apply a coat of grease to outer diameter of the pin (21) and bushing (7).
2. Apply a coat of grease to inner diameter of the spacer (22), traction pedal
pin (25) and linkage bellcrank (5).
3. Assemble the traction pedal using the
4. After the traction pedal assembly, make sure that there is no binding in pedal
movement. Ensure that the traction pedal returns to the centered position
when released. Correct any sticking or binding before the machine operation.
5. Plug the machine wire harness connectors into the micro switches.
6. After assembly of the traction pedal, adjust the traction pedal; refer to
Operator's Manual. Make sure that the traction rod does not contact anything
through both forward and reverse directions.
7. Connect positive battery cable from battery terminal and then connect
negative cable to battery; refer to Operator's Manual.
Figure 146
Page 7–13
Figure 146 as a guide.
as a guide.
Chassis: Service and Repairs