Service And Repairs; Wheels - Toro ProLine H800 Service Manual

Service and Repairs

Wheels

g289305
1. Rear wheel hub
2. Rear wheel lug bolt
3. Washer
Removing the Wheels
ProLine H800
19241SL Rev A
4. Rear wheel assembly
5. Front wheel assembly
6. Front wheel lug nut
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Block the wheels that are not removed with chocks to prevent the machine
from moving.
3. Loosen, but do not remove the wheel-lug nuts or bolts that attach the wheel
to the machine.
Before lifting the machine with a jack, review and follow
Instructions (page 1–7).
4. Lift the machine with a jack until the wheel to be removed is off the ground.
Support the machine with appropriate jack stands.
5. Remove the wheel-lug nuts or bolts that attach the wheel to the machine,
and remove the wheel.
Figure 139
IMPORTANT
Page 7–3
7. Front wheel hub
Jacking
Chassis: Service and Repairs