Toro ProLine H800 Service Manual page 215

Testing the Hazard Light Switch (continued)
ProLine H800
19241SL Rev A
5. The hazard light switch terminals are identified in
of the hazard light switch is shown in the
With the use of a multimeter (ohms setting), test the switch functions to
determine if the continuity exists between the various terminals for each
switch position. Check the continuity between the switch terminals.
Circuit Logic Table
Switch Position
ON
OFF
6. Replace the hazard light switch if the testing determines it is damaged.
7. If the hazard light switch testing is correct and a circuit problem still exists,
check the wire harness; refer to the Electrical Schematics and Wire Harness
Drawings/Diagrams in
8. After you complete the testing, connect the machine wire harness connector
to the hazard light switch.
9. Install the dash panel to the steering column; refer to
Assembly (page 7–7).
10. Connect the battery negative (-) cable to the battery.
Circuit Logic Table (page
Appendix A (page A–1).
Page 6–15 Electrical System: Testing the Electrical Components
Figure 112 and the circuitry
6–15).
Closed Circuits
2 + 3, 5 + 6
2+ 1, 5 + 4
Assembling the Body