Toro ProLine H800 Service Manual page 132

After Repairing or Replacing the Components (continued)
Hydraulic System: Service and Repairs
4. Use proper tightening procedures when installing the hydraulic hoses and
fittings; refer to Installing the Hydraulic Hoses and Tubes (page 5–8)
Installing the Hydraulic Fittings (page
5. After you complete the repairs, check the control linkages or cables for
proper adjustment, binding, or broken parts.
6. Whenever hydraulic fluid has been drained from the pumps (system drain,
flush, or pump removal/installation) it is important to properly prime the
hydraulic pumps, refer to
7. After you disconnect or replace any hydraulic component, operate the
machine functions slowly until the air is out of the system; refer to
the Hydraulic System (page
8. Check for hydraulic-fluid leaks. Shut off the engine and repair leaks if
necessary.
5–10).
Priming the Hydraulic Pump (page
5–72).
Page 5–64
and
5–70).
Charging
ProLine H800
19241SL Rev A