Toro ProLine H800 Service Manual page 61

Removing the Fuel Tank
g289124
1. Bolt
2. Washer
3. Nut
4. Washer
ProLine H800
19241SL Rev A
5. Nut
6. Cross rail
7. Rubber grommet
8. Bolt
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Raise and lock the hopper assembly; refer to Operator's Manual.
3. Remove the battery negative cable from the negative post of the battery.
4. Allow the engine to completely cool.
5. Unplug the wire harness connections of fuel tank float.
6. Use a fuel transfer pump to remove the fuel from the fuel tank and into a
certified fuel storage.
7. Loosen the hose clamps and carefully disconnect the fuel hoses from the
fuel tank float on top of the fuel tank.
Note: Before removing the fuel hoses from the fuel tank, label the hoses for
assembly purposes.
Figure 19
10.
11.
Page 4–13
9. Bolt
Fuel tank support
Fuel tank
Engine: Service and Repairs