Servicing The Driveshaft - Toro ProLine H800 Service Manual

Servicing the Driveshaft

g290288
1. End yoke
2. Universal joint kit (cross and
bearing)
Disassembling the Driveshaft
Axle and PTO: Service and Repairs
3. Grease fitting
4. Slip shaft yoke
1. Remove the PTO driveshaft from the machine; refer to
Driveshaft (page 8–18).
g290289
1. End yoke
2. Cross and bearing kit
3. Snap ring
2. Remove the snap rings (3) that secures the cross and bearing kit in the yokes.
Support the yokes when removing and installing the bearings to
prevent damage.
3. Use a press to remove the cross and bearing (2) from the yokes.
4. Clean the driveshaft yoke (5) and end yoke (1).
5. Inspect the driveshaft yoke (5) and end yoke (1) for wear, pitting or other
noticeable damage. Replace the parts that are worn or damaged.
Figure 160
Figure 161
4. Grease fitting
5. Shaft yoke
IMPORTANT
Page 8–20
5. Slip tube yoke
6. End yoke
Removing the PTO
19241SL Rev A
ProLine H800