Height Of Cut Circuit - Toro ProLine H800 Service Manual

Height Of Cut Circuit

g292157
Hydraulic System: Hydraulic Flow Diagrams
The charge pump supplies fluid pressure to the steering circuit, height of cut
circuit and auxiliary circuit. The charge pump is fed through a filter from the
hydraulic tank. The pump output flows to the steering control valve first before
reaching the height of cut circuit. When the height of cut is not being adjusted
higher or lower, fluid flow enters the height of cut control valve manifold at the P
port and exits from the T port.
Figure 34
Page 5–22 ProLine H800
19241SL Rev A