Toro ProLine H800 Service Manual page 36

Specifications and Maintenance: Special Tools
High Flow Hydraulic Filter Kit
K-Line Part No: TOR6011
The high flow hydraulic filter kit is designed with
large flow (150 LPM or 40 GPM) and high pressure
(34,500 kPa or 5,000 psi) capabilities. This kit
provides for bi-directional filtration which prevents
filtered unwanted material from entering into the
circuit regardless of the flow direction.
If a component failure occurs in the closed loop
traction circuit, contamination from the damaged
part will remain in the circuit until you remove it.
Install a high flow hydraulic-fluid filter into the circuit
when you connect the hydraulic test gauges in
order to test the traction circuit components or after
you replace a failed traction circuit component
(e.g., piston pump or wheel motor). This filter
removes contamination from the hydraulic fluid in
the traction circuit, thereby preventing additional
component damage.
Note: This kit does not include the hydraulic hoses;
refer to Hydraulic Hose Kit (page
Note: The replacement filter element is Toro
Part No. TOR6012. The filter element canister
tightening torque is 34 N∙m (25 ft-lb).
Wheel Hub Puller
K-Line Part No: TOR6004
The wheel hub puller allows you to safely remove
the wheel hub from the wheel motor shaft.
Note: The replacement filter element is Toro
Part No. TOR6012. The filter element canister
tightening torque is 34 N∙m (25 ft-lb).
2–16).
Page 2–18 ProLine H800
19241SL Rev A