Removing the Front Wheel Motors (continued)
ProLine H800
19241SL Rev A
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Block the rear wheels with chocks to prevent the machine from moving.
3. Loosen, but do not remove the locknut (item 5 in Figure
secures the wheel hub to the wheel motor.
4. Read the
General Precautions for Removing and Installing the Hydraulic
System Components (page
Before lifting the machine with a jack, review and follow
Instructions (page
1–7).
5. Lift the machine with a jack to remove the front wheel, support the machine
with jack stands.
6. Remove the front wheel, brake drum, wheel hub, and brake assembly from
the machine; refer to
5–63).
IMPORTANT
Servicing the Brake (page
Page 5–93
Figure
77) that
Jacking
8–3).
Hydraulic System: Service and Repairs