Toro ProLine H800 Service Manual page 190

Removing the Hopper Tilt Cylinder (continued)
Hydraulic System: Service and Repairs
g294041
1. Female quick coupler
2. Bracket
3. Hose
4. Bolt
5. O-ring
6. Hose
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
4. Disconnect the hydraulic hoses from the fittings in the hopper tilt cylinder that
is to be removed. Allow the hoses to drain into a suitable container. Remove
and discard the O-rings from the fittings.
5. Install clean caps or plugs on the hydraulic hoses and fittings to prevent
contamination.
6. Remove the nut (item 2 in
cylinder (7) to the hopper frame (1).
7. Remove the bolt (10), washer (9) and pin (8) that secures the hopper tilt
cylinder (7) to the support frame (11).
8. Remove the hopper tilt cylinder from the machine.
Figure 95
7. Hose
8. Hose
9. Bolt
10. Hydraulic cylinder
11. Auxiliary control valve
12. Hose
WARNING
Releasing Pressure from the
5–5).
Figure 94) and bolt (4) that secures the hopper tilt
Page 5–122 ProLine H800
19241SL Rev A