Service And Repairs; Hopper Assembly - Toro ProLine H800 Service Manual

Service and Repairs

Hopper Assembly

g291254
1. Bolt
2. Washer
3. Pin
4. Bolt
Removing the Hopper Assembly
ProLine H800
19241SL Rev A
5. Washer
6. Flange bushing
7. Nut
8. Hydraulic cylinder
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake and remove the key from the key switch.
2. Disconnect the hopper micro switch connector from the machine wire
harness.
3. Support the hydraulic actuators (8) before loosening the mounting fasteners.
4. Remove the nut (10) and bolt (9) that secures the hydraulic cylinder to the
hopper assembly.
Figure 166
10.
Page 9–3
9. Bolt
Nut
Hopper Assembly: Service and Repairs