Toro ProLine H800 Service Manual page 311

1. Tube cap
2. Tube
3. Clamp
4. Cap
5. Washer
6. Nut
7. Bolt
8. Washer
9. Bracket
10. Thread insert
11. Bolt
12. Arm
13. Arm
14. Grease fitting
15. Support
16. Nut
17. Hydraulic cylinder
18. Rubber pad
19. Nut
Disassembling the Hopper Lift Frame Assembly
ProLine H800
19241SL Rev A
Figure 170 (continued)
20. Collar
21. Hopper hinge
22. Socket head screw
23. Nut
24. Pin
25. Washer
26. Bolt
27. Support frame
28. Screw
29. Support
30. Chassis
31. Magnet
32. Safety handle
33. Snap ring
34. Nut
35. Bushing
36. Bolt
37. Hydraulic cylinder
38. Spring
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake and remove the key from the key switch.
2. Remove the hopper assembly from the machine; refer to
Hopper Assembly (page
3. For assembly purposes, tag the hydraulic hoses to show their correct position
on the hydraulic cylinders.
4. Disconnect the hydraulic hoses from the hydraulic cylinders. Install the
clean caps or plugs on the hydraulic hoses and fittings to prevent hydraulic
system contamination.
5. Disassemble the hopper lift frame assembly using the
171 as a guide.
g291460
1. LH Bracket
2. Bolt
3. Washer
39.
40.
41.
42.
43.
44.
45.
46.
47.
48.
49.
50.
51.
52.
53.
54.
55.
9–3).
Figure 171
4. Nut
5. Chassis
Page 9–11
Pin
Nut
Ball joint
Arm
RH Bracket
LH Bracket
Snap ring
Pin
Washer
Plate
Nut
Cable
Knob
Pin
Roll bar
Socket head screw
Bolt
Removing the
Figure 170 and
Hopper Assembly: Service and Repairs
Figure