Toro ProLine H800 Service Manual page 312

Assembling the Hopper Lift Frame Assembly
Hopper Assembly: Service and Repairs
1. Clean the pin (24). Inspect the pin (24) for wear or damage and replace
if necessary.
2. Assemble the hopper lift frame assembly using the
171 as a guide.
3. Remove the caps or plugs that were installed to the hydraulic hoses and
fitting during the disassembly process.
4. Use the tags that marked during disassembly to correctly connect the
hydraulic hoses to the hydraulic cylinders.
5. Install the hopper assembly onto the machine frame; refer to
Hopper Assembly (page
6. Check and align the hopper assembly to the chute seal; refer to Operator's
Manual.
7. Lubricate the grease fittings; refer to Operator's Manual.
8. Check the hydraulic fluid level in the hydraulic tank; refer to Operator's
Manual.
9. Check for correct operation of the hopper lift frame assembly.
10. Check the hydraulic cylinder connections for leaks.
9–4).
Page 9–12
Figure 170 and Figure
Installing the
ProLine H800
19241SL Rev A