Cutting Deck Rollers And Skids - Toro ProLine H800 Service Manual

Cutting Deck Rollers and Skids

g290972
1. Bolt
2. Washer
3. Washer
4. Nut
5. Roller shaft
6. Roller
7. Bolt
Removing the Cutting Deck Rollers and Skids
Installing the Cutting Deck Rollers and Skids
Cutting Unit: Service and Repairs
8. LH skid
9. Washer
10. Nut
11. Carriage bolt
12. Pin
13. Roller pin
14. Bearing
1. Park the machine on a level surface, raise the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Remove the cutting deck rollers and skids from the cutting deck using the
Figure 178 as a guide.
1. Install the skids to the cutting deck using the
to install the skids in the same mounting hole height position (lower or upper).
Figure 178
15.
16.
17.
18.
19.
Page 10–14
Roller
Washer
Bolt
RH skid
Cutting deck
Figure 178 as a guide. Ensure
ProLine H800
19241SL Rev A