Toro ProLine H800 Service Manual page 329

Installing the Cutting Deck Rollers and Skids (continued)
ProLine H800
19241SL Rev A
2. Install the cutting deck rollers to the cutting deck using the
guide. Tighten the nut (4) until the roller will not rotate, then loosen the nut
only enough to allow the roller to rotate freely. Ensure to install the cutting
deck rollers in the same mounting hole height position (lower or upper).
3. Check and adjust the level of the cutting deck; refer to Operator's Manual.
Page 10–15
Figure 178 as a
Cutting Unit: Service and Repairs