Toro ProLine H800 Service Manual page 67

Installing the Engine (continued)
ProLine H800
19241SL Rev A
H. PTO clutch wire connector.
8. Using the notes that you recorded during removal, secure the wires with
cable ties in proper locations.
9. Install the electric clutch onto the engine; refer to
(page 8–16).
10. Install the PTO driveshaft onto the machine; refer to
Driveshaft (page 8–19).
11. Install the exhaust pipe onto the engine; refer to
System (page 4–6).
12. Install the air cleaner assembly onto the engine; refer to
Cleaner Assembly (page
13. Install the engine front, top and rear covers; refer to
7–19).
14. Install the radiator onto the machine; refer to
4–10).
15. Service the cooling system; refer to the Operator's Manual.
16. Install the fuel tank onto the machine; refer to
4–14)).
17. Add fuel to the fuel tank; refer to the Operator's Manual.
18. Install the chute assembly onto the machine; refer to Operator's Manual.
19. Install the hopper assembly onto the machine; refer to
Assembly (page 9–4).
20. Connect both the battery cables to the battery. Connect the positive battery
cable and then the battery negative cable.
21. Ensure that all the wires, fuel lines, hydraulic hoses, and cables are clear of
moving parts and secured to their original locations.
22. Check the engine oil level and adjust as necessary; refer to the Operator's
Manual.
23. Prime the fuel system; refer to
24. Start the engine and operate the hydraulic controls to properly fill the
hydraulic and engine coolant systems; refer to
System (page 5–72)
4–4).
Priming the Fuel System (page
and refer to proper coolant fill procedure.
Page 4–19
Installing the Electric Clutch
Installing the PTO
Installing the Exhaust
Installing the Air
Frame Assembly (page
Installing the Radiator (page
Installing the Fuel Tank (page
Installing the Hopper
4–12).
Charging the Hydraulic
Engine: Service and Repairs