Toro ProLine H800 Service Manual page 307

Disassembling the Hopper Frame Assembly
Assembling the Hopper Frame Assembly
ProLine H800
19241SL Rev A
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake and remove the key from the key switch.
2. Remove the hopper assembly from the machine; refer to
Hopper Assembly (page
3. Disassemble the hopper frame assembly using the
168 as a guide.
4. If required, disassemble the hopper; refer to
(page 9–9).
1. If disassembled, assemble the hopper; refer to
(page 9–9).
2. Assemble the hopper frame assembly using the
as a guide.
3. Install the hopper assembly onto the machine frame; refer to
Hopper Assembly (page
4. Check and align the hopper assembly to the chute seal; refer to Operator's
Manual.
5. Lubricate the grease fittings; refer to Operator's Manual.
6. Check for correct operation of the hopper assembly and adjust the hopper
assembly sensor; refer to Operator's Manual.
9–3).
9–4).
Page 9–7
Removing the
Figure 167 and
Disassembling the Hopper
Assembling the Hopper
Figure 167 and Figure 168
Installing the
Hopper Assembly: Service and Repairs
Figure