Toro ProLine H800 Service Manual page 66

Installing the Engine
Engine: Service and Repairs
Ensure that all parts removed from the engine during maintenance
or overhaul are correctly installed on the engine.
1. Park the machine on a level surface and remove the key from the key switch.
Block the wheels with chocks to prevent the machine from moving.
2. If the engine brackets were removed from the engine, install the brackets to
the engine (Figure
The engine is very heavy, and a hoist not rated for the weight of the
engine may fail, causing possible injury and damage to the engine.
Use hoist equipment rated to lift the engine, which is approximately
135 kg (298 lb).
3. Attach a suitable lift or hoist to the lift tabs on the front and rear of the engine.
Support the engine with lift or hoist to prevent the engine from shifting or
moving.
Use 1 person to operate the lift or hoist while the other person
guides the engine into the machine.
When installing the engine ensure that you do not damage the
engine, fuel hoses, hydraulic lines, electrical harness, radiator or
other parts.
4. Carefully lower the engine to the machine frame. Ensure that the fastener
holes of the engine brackets are aligned with the holes in the engine shock
mount.
5. Secure the engine to the engine mount brackets
6. Install the hydraulic piston pump and gear pump onto the engine; refer to
Installing the Hydraulic Pump Assembly (page
7. Connect all the wire harness connectors to the following engine components:
A. Alternator connector and stud.
B. Oil pressure switch located near the engine oil filter.
C. Connector and positive battery cable to the starter motor.
D. High temperature shut down switch and temperature sender located on
the water pump housing.
E. Fuel stop solenoid on the injector pump.
F. Battery negative cable to the injector pump.
G. Glow plug strip.
IMPORTANT
20).
CAUTION
CAUTION
IMPORTANT
Page 4–18
(Figure 20).
5–84).
ProLine H800
19241SL Rev A