Toro ProLine H800 Service Manual page 225

Testing the Height Of Cut Switch (continued)
ProLine H800
19241SL Rev A
5. The switch terminals are identified in
switch is shown in the
multimeter (ohms setting), test the switch functions to determine if continuity
exists between the various terminals for each switch position.
Circuit Logic Table
Switch Position
R
AISE
OFF
LOWER
Note: The switch terminals 1, 2, and 3 are not used.
6. Replace the height of cut switch if testing determines that the switch is
damaged.
7. If the switch testing is correct and a circuit problem still exists, check
the wire harness; refer to the Electrical Schematics and Wire Harness
Drawings/Diagrams in
8. After you complete the testing, connect the wire harness connector to the
switch.
9. Install the left arm control panel to the machine; refer to
Body Assembly (page
Figure 122
Circuit Logic Table (page
Appendix A (page A–1).
7–7).
Page 6–25 Electrical System: Testing the Electrical Components
and the circuitry of the
6–25). With the use of a
Closed Circuits
5 + 4
None
5 + 6
Assembling the