Toro ProLine H800 Service Manual page 309

Disassembling the Hopper
Assembling the Hopper
ProLine H800
19241SL Rev A
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake and remove the key from the key switch.
2. Remove the hopper assembly from the machine; refer to
Hopper Assembly (page
3. Disassemble the hopper using the
4. Note the location of the electrical connectors for assembly purposes.
1. Assemble the hopper using the
2. Connect the electrical connectors as noted during the disassembly.
3. Install the hopper assembly onto the machine frame; refer to
Hopper Assembly (page
4. Check and align the hopper assembly to the chute seal; refer to Operator's
Manual.
5. Lubricate the grease fittings; refer to Operator's Manual.
6. Check for correct operation of the hopper assembly and adjust the hopper
assembly sensor; refer to Operator's Manual.
9–3).
Figure 169
Figure 169 as a guide.
9–4).
Page 9–9
Removing the
as a guide.
Installing the
Hopper Assembly: Service and Repairs