Toro ProLine H800 Service Manual page 247

Removing and Installing the Battery (continued)
ProLine H800
19241SL Rev A
g216923
3. Loosen and remove the negative (-) cable from the battery. After you
disconnect the negative cable from the battery, loosen and remove the
positive cable (+) from the battery
4. Loosen the bolt that secures the battery retainer.
5. Carefully remove the battery from the machine.
6. Install the battery in reverse order and ensure to connect and tighten the
positive (+) cable to the battery before connecting negative (-) cable. Use 2
wrenches when tightening the cables.
Note: Before connecting the negative (ground) cable to the battery, connect
a digital multimeter (set to DC Amps) between the negative battery post and
the negative (ground) cable connector. The reading should be less than 0.1
A. If the reading is 0.1 A or more, the electrical system of the machine should
be tested for short circuits or damaged components and repaired.
7. Install the left console onto the machine; refer to
Assembly (page 7–7).
Figure 138
(Figure 138).
Page 6–47
Assembling the Body
Electrical System: Service and Repairs