Height Of Cut Switch - Toro ProLine H800 Service Manual

Height Of Cut Switch

g294710
1. Height of cut switch
Testing the Height Of Cut Switch
Electrical System: Testing the Electrical Components
The height of cut switch is used to adjust the mower deck cutting height. The
switch is located on the left console.
The engine must be running to allow the height of cut to be raised or lowered.
The height of cut switch controls the solenoid valve coils on the height of cut
control valve.
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. Ensure that the key switch is in the OFF position and the key is removed
from the key switch.
3. Remove the left arm control panel and get access to rear of the switch; refer
to Disassembling the Body Assembly (page
4. Disconnect the wire harness connector from the height of cut switch.
g223017
Figure 121
Figure 122
Page 6–24
7–6).
ProLine H800
19241SL Rev A