Lift Cylinder - Toro ProLine H800 Service Manual

Lift Cylinder

g293858
1. Pin
2. Grease fitting
3. Support
4. Washer
5. Nut
Removing the Lift Cylinder
ProLine H800
19241SL Rev A
6. Nut
7. Lift cylinder
8. Breather cap
9. Washer
10. Nut
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
3. For assembly purposes, label all the hydraulic connections. Clean the
hydraulic connections before loosening the hydraulic lines from the lift
cylinder.
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
Figure 86
11.
12.
13.
5–63).
CAUTION
Releasing Pressure from the
5–5).
Page 5–109
Washer
Pin
LH lift arm
Hydraulic System: Service and Repairs