Electric Clutch - Toro ProLine H800 Service Manual

Electric Clutch

g290631
1. Bolt
2. Washer
3. Bushing
4. Bracket
Removing the Electric Clutch
ProLine H800
19241SL Rev A
5. Spring
6. Electric clutch
7. Woodruff key
8. Bolt
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Disconnect the electrical connector from the electric clutch.
3. Remove the PTO drive belt from the machine; refer to Operator's Manual.
4. Remove the bolt (1) and washer (2) that secures the electric clutch (6) to the
drive shaft (10).
5. Slide and remove the electric clutch (6) and bushing (3) from the drive shaft
(10).
6. Locate and retrieve the woodruff key (7).
7. If required, remove the drive shaft (10) from the engine (11) by removing the
3 bolts (8) and washers (9).
Figure 157
10.
11.
Page 8–15
9. Washer
Drive shaft
Engine
Axle and PTO: Service and Repairs