Toro ProLine H800 Service Manual page 114

Test Procedure (continued)
Hydraulic System: Testing the Hydraulic System
5. Access the hydraulic pump from left side as below:
g216339
1. Bolt
A. Remove the bolt (item 1) from the bracket (tem 2) and rotate the fuel tank
to the right to access the hydraulic pump.
Note: You must have the steering wheel rotated to the fully left locked
position to rotate the fuel tank fully.
6. Ensure that the traction pedal is correctly adjusted for the NEUTRAL position.
Also, ensure that the hydraulic pump is at full stroke when traction pedal
is pressed fully in forward position.
7. Lift and support the machine so that all wheels are off the ground; refer to
Jacking Instructions (page
g292559
1. Hydraulic pump
2. O-ring
3. Fitting
4. T fitting adaptor
5. Pressure port plug
8. Clean the junction of the hydraulic hose and left side of the fitting on bottom
of the hydraulic pump
Figure 53
2. Fuel tank bracket
1–7).
Figure 54
6. Hose
7. Hydraulic motor
8. Fitting
9. Hose
10. Hose
(Figure 54), and disconnect the hose from the fitting.
Page 5–46 ProLine H800
19241SL Rev A