Removing the Height Of Cut Valve (continued)
g293798
1.
Quick disconnect coupler
2.
O-ring
3.
Bracket
4.
Hose
ProLine H800
19241SL Rev A
5.
Bolt
6.
Fitting
7.
Height of cut valve
8.
Bolt
5. Disconnect the hydraulic hoses and tubes from the fittings in the height of
control valve. Allow the lines to drain into a suitable container. Remove and
discard the O-rings from the fittings.
6. Install clean caps or plugs on the hydraulic lines and fittings to prevent
system contamination.
7. Remove the 2 bolts (item 4 in
height of cut valve to the operator platform.
8. Remove the height of control valve from the machine.
9. If necessary, remove the hydraulic fitting from the height of cut valve. Discard
the O-rings that were removed.
Figure 85
10.
11.
12.
Figure
84) and washers (5) that secure the
Page 5–107
9.
Hose
Hose
Auxiliary control valve
Steering control valve
Hydraulic System: Service and Repairs