Chute Assembly - Toro ProLine H800 Service Manual

Chute Assembly

g291632
1. Chute
2. Handle
3. Screw
4. Bracket
5. Pin
Disassembling the Chute Assembly
Assembling the Chute Assembly
ProLine H800
19241SL Rev A
6. Bracket
7. Chute rubber seal
8. Nut
9. Screw
10. Plate
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake and remove the key from the key switch.
2. Remove the chute assembly from the machine; refer to Operator's Manual.
3. Disassemble the chute assembly using the
1. Assemble the chute assembly using the
2. Install the chute assembly onto the machine; refer to Operator's Manual.
Figure 172
11.
12.
13.
14.
Figure 172
Page 9–13
Washer
Nut
Pin
Chute bracket
Figure 172 as a guide.
as a guide.
Hopper Assembly: Service and Repairs