Testing The Electrical Components - Toro ProLine H800 Service Manual

Testing the Electrical Components

Electrical System: Testing the Electrical Components
For accurate resistance and/or continuity checks, electrically disconnect the
component being tested from the circuit (e.g., unplug the key switch connector
before doing a continuity check of the switch).
Note: Electrical troubleshooting of any 12 V power connection can be performed
through voltage drop tests without disconnecting the component.
Note: For engine component testing information; refer to
Service Manual and Yanmar 3TNV80F Service
When testing the electrical components for continuity with a
multimeter (ohms setting), ensure that you disconnect the power to
the circuit.
IMPORTANT
Page 6–6
Yanmar 3TNV76
Manual.
ProLine H800
19241SL Rev A